Watco Flowpatch Standard Plaster
FLOWPATCH STANDARD PLASTER
FLOWPATCH STANDARD PLASTER
Flowpatch® is an easy to mix, pourable material for fast repairs to level concrete surfaces both inside and outside.
It is fiber reinforced for extra strength and hardens quickly - it will accept heavy traffic including forklifts only 2 hours after application.
INFORMATION
SKU
- 10lb : A050606
- 55lb : A050606
BRAND
Watco Floor
PRODUCT TYPE
Plaster
PRIMER REQUIRED
No
SUITABLE FOR
Concrete
FEATURES
Quick setting, pourable flooring patch that repairs holes, gouges, spalling, crevices or pitted concrete
ABLE TO PART MIX
3 parts powder to 1 part water by volume
USAGE INTERIOR/EXTERIOR
Interior or Exterior
REINFORCED
Fiber reinforced
FOOT TRAFFIC
Ready for foot traffic after 30 min. & forklift traffic after 2 hours
FINISH
Silver Gray, slip resistant finish
POT LIFE
5-10 Minutes in 70°F
THICK
Covers approximately 5.5 sq. ft. per 55 lb. kit at 1" thick
EDGE
Can be applied from fine edge to 4"
TEMPERATURES
Sets at temperatures as low as 41°F
SURFACES
Apply to dry or damp (not wet) surfaces
SURFACE PREPARATION
The substrate should be clean and free from oil or contaminants. Loose debris should be removed and the surface wire brushed. Flowpatch can be applied to damp (not wet) concrete.
APPLICATION
For use on interior and exterior surfaces
INCLUDING
Includes mixing cup for partial mixing
MIXING
Do not mix more than you can use within 10 minutes. Mixing Ratio is 3 parts Flowpatch powder to 1 part water by volume. Gradually add the Flowpatch powder/aggregate to water mixing continuously with a mixing blade on a drill to achieve pourable slurry. Thoroughly mix the sides and base of the powder in the bucket to break up any lumps of unmixed dry powder. Once mixed, curing begins very quickly, so the mixture should be applied immediately. Once thoroughly mixed, do not re-stir as this could potentially weaken the final repair. The remaining powder/aggregate can be stored for future use. Pot Life is 5 to 10 minutes at 70°F.
TYPICAL PSI STRENGTH AT 70°F
- Day 1 = 2,900 PSI
- Day 7 = 5,000 PSI
- Day 28 = 6,500 PSI
COVERAGE
5.5 sq. ft per 55 lb. kit at 1" thick
CURING TIME (HOURS)
1 Hour in 60°F, Heavy traffic including forklifts in 2 hours
APPLICATION
When a smooth consistency has been produced, simply pour Flowpatch® into the damaged area. After proper mixing, the repair will self-level and need minimal trowelling. Flowpatch resists oils and grease.
