Watco Industrial Flooring, Inc.

Watco Floors Flowpatch Deep Fill Plaster

FLOWPATCH DEEP FILL PLASTER

Watco Floors Flowpatch Deep Fill Plaster

FLOWPATCH DEEP FILL PLASTER

Flowpatch® Deep Fill is an easy to mix, pourable material for fast repairs to level concrete surfaces both inside and outside.

This Deep Fill formula is perfect for repairing or levelling deeper holes between 1cm-8in in concrete flooring.

INFORMATION

INCLUDES MIXING CUP

Includes mixing cup for partial mixing

BRAND

Watco Floor

PRODUCT TYPE

Plaster

Watco Floors Flowpatch Deep Fill Plaster

SKU

A1170665

COLLECTION

Flowpatch

APPLICATION

When a smooth consistency has been produced, simply pour Flowpatch® into the damaged area. After proper mixing, the repair will self-level and need minimal trowelling. Flowpatch resists oils and grease.

SURFACE PREPARATION

The substrate should be clean and free from oil or contaminants. Loose debris should be removed and the surface wire brushed. Flowpatch can be applied to damp (not wet) concrete.

Watco Floors Flowpatch Deep Fill Plaster

QUANTITY

1

PRIMER REQUIRED

No

COVERAGE

2.5 sq. ft per 55 lb. kit at 2" thick

USAGE INTERIOR/EXTERIOR

Interior or Exterior

TEMPERATURE

Sets at temperatures as low as 41°F

FEATURES AND BENEFITS OF FLOWPATCH® DEEP FILL

- For use on interior and exterior surfaces.
- Apply to dry or damp (not wet) surfaces.
- Can be applied to deeper holes between 1cm-8in.
- Covers approximately 2.5 sq. ft. per 55 lb. kit at 2" thick.
- Ready for foot traffic after 30 min. & forklift traffic after 2 hours.
- Quick setting, pourable flooring patch that repairs holes, gouges, spalling, crevices or pitted concrete.

Watco Floors Flowpatch Deep Fill Plaster

POT LIFE

5-10 Minutes in 70°F

CURING TIME

1 Hour in 60°F

REINFORCED

Fiber Reinforced

SUITABLE FOR

Concrete

ABLE TO PART MIX

6 parts powder to 1 part water by volume

FINISH

- Silver Gray
- Slip resistant finish

HOW TO REPAIR CONCRETE HOLES WITH WATCO FLOWPATCH

See how easy it is to repair damages in concrete, like holes, ...

MIXING

Do not mix more than you can use within 10 minutes. Mixing Ratio is 6 parts Flowpatch powder to 1 part water by volume. Gradually add the Flowpatch powder/aggregate to water mixing continuously with a mixing blade on a drill to achieve pourable slurry. Thoroughly mix the sides and base of the powder in the bucket to break up any lumps of unmixed dry powder. Once mixed, curing begins very quickly, so the mixture should be applied immediately. Once thoroughly mixed, do not re-stir as this could potentially weaken the final repair. The remaining powder/aggregate can be stored for future use. Pot Life is 5 to 10 minutes at 70°F.

Watco Industrial Flooring, Inc.
T +1 855 6276350
Watco Industrial Flooring, Inc.
11 E Hawthorn Pkwy, Vernon Hills, IL 60061, United States