Watco Floors Powerfloat Sealer Anti-Slip
POWERFLOAT SEALER ANTI-SLIP
POWERFLOAT SEALER ANTI-SLIP
Watco Powerfloat Sealer Anti-Slip is specially designed for very smooth, hard, powerfloated concrete floors.
Such surfaces should usually be shotblasted or ground to provide a key, but this unique epoxy resin formulation can be simply applied by roller directly to the smooth surface.
INFORMATION
COVERAGE
Coverage: 320ft² in one layer. A single layer is generally sufficient. However, two coats may be necessary on a porous ground.
BRAND
Watco Floor
PRODUCT TYPE
Paint
SKU
B11519145
RECOMMENDED NUMBER OF COATS
1
REMOVING THE NEED FOR BLASTING OR TEXTURING
Removing the need for blasting or texturing means the attractive smooth surface of the concrete is maintained, and costly shotblasting work is avoided. One coat seals, dustproofs, protects and creates a safer, non-slip surface.
SURFACE PREPARATION
New concrete should be allowed at least 28 days to dry. Surfaces should be clean, dry and free from oil, grease, dust, dirt and other contaminants. Existing coatings should be well bonded and sound.
CURING TIME
16 hours at 59-68°F
POT LIFE
2 hours at 68°F
FINISH
Clear, fine textured
WET PTV
56 Low slip potential
DRY PTV
69 Extremely low slip potential
MIXING
The tall outer tin contains a tin of Resin and a tin of Curing Agent. Remove these two tins and stir the contents of each thoroughly. Decant both tins into the tall outer tin. The two components should then be very thoroughly mixed together using a wide bladed stirrer. Mix for 2-3 minutes until an even consistency is obtained. Both liquids are opaque white/off white in color and it is important to ensure complete mixing to allow the cure reaction to happen.
FLOORING SURFACE
Helps to retain the attractive, smooth flooring surface
FEATURE
-Provides a fine textured anti-slip surface. -Tough, easy-to-clean epoxy resin formula.
USAGE INTERIOR/EXTERIOR
Exterior
SUITABLE FOR
Powerfloated or very smooth concrete
DRYING TIME
16 hours at 60-70°F for heavy traffic
APPLICATION
Decant the mixed components into a roller tray and apply using a medium pile type roller. A brush may be used for cutting in. Aim to apply the mixed components within one hour (they are useable for up to 2 hours maximum at 70°F). Do not apply at temperatures below 50°F or above 85°F. Cold or damp conditions may prevent full curing. Avoid applying too thick. The two components for Powerfloat Sealer are white, but the coating will cure to a clear finish within 2 hours.
