Carlisle Handknit Plank Flooring
HANDKNIT PLANK FLOORING
HANDKNIT PLANK FLOORING
A gentle white finish allows the grain of the wood to peek through but bathes these planks in creamy softness.
The whitewash transforms knotholes and their fill to a lovely gray, giving the planks an understated visual texture. Inspired by the warmth and comfort of a handknit sweater, this floor’s character is as at home in a modern loft as in an old farmhouse.
INFORMATION
BRAND
Carlisle
PRODUCT TYPE
Flooring
WIDTH
7"
LENGTH
2′ – 10′ Random
ENGINEERED WOOD FLOORING
-9-11 Layers-Plywood substrate -Hardwood wear layer dry sawn veneer -California Air Resource Board (CARB2) compliant -Moisture content of wear layer at time of manufacture may be from 6-9% -Wear layer thickness of 4mm nominal (specified textures and finishing process may slightly alter finished thickness)
FINISH
Prefinished
USE
Indoor
TEXTURE
Smooth
EDGE
Softened
SHEEN
Super Matte
GRADE
Signature
STRUCTURE
Engineered
PROFILE
- Tongue
- Groove
SPECIES
White Oak
MINIMUM ORDER
400 SQ FT
MANUFACTURING PROCESS
- Product must be made in the USA
- Hot glue process for engineered structure
- Multi-point individual board press laminating process
WOOD SUBFLOOR
Wood subfloors are not to exceed 12% and should be within 2% of the moisture content of the flooring material prior to starting installation, when sam- pled using an appropriate resistance (pin-type) meter.
INSTALLATION
- Plywood
- Waterfront
- Residential
- Commercial
- Radiant Heat
- Concrete Slab
SURFACE
Wood subfloors that allow for nailing (at industry prescribed schedule) require at minimum; the use of a caulking gun (such as Wakol MS 265) adhesive bead, applied across the full width of the planks at intervals of 8-12” in addition to mechanical fastening. Full-spread wood flooring adhesive applied by trowel to the substrate surface is recommended and will provide the most optimal method of glue-assist.
DETAIL
-Flooring should be installed in the direction recommended by the Architect or Designer or parallel to the longest wall. -Expansion space of at least ½” is required around the perimeter of the installation in each room. -Installation using full-spread glue requires the of use appropriate surface weight to properly set the individual board into the adhesive. Adhesive transfer of 95% or more to the bottom of the plank is required and must retain contact with the adhesive and substrate once dry and cured. 5 gallon buckets filled with sand or water are most commonly used for this purpose. Depending on adhesive requirement weights can typically be redistributed after 20 minutes.
MATERIAL
- American White Oak
- 7ژٓwide planks, 2’-1’ random lengths
- T and G edge joints and end matches
- NWFA/NOFMA Certified Manufacturer
- Engineered Ǒlooring is זٖד” total thickness.
- Softened edge on the 2 long sides of each plank of 1/32".
- Grade of material is a proprietary grade created by Carlisle. ژWood Filler is used in certain characterics within the plank face
COLORS
ALL COLORS
