Carlisle Fireside Tale Flooring
FIRESIDE TALE Flooring
FIRESIDE TALE FLOORING
Fireside Tale celebrates the rustic casualness of campfires, hand-split logs and forest getaways.
INFORMATION
BRAND
Carlisle Wide Plank Floors
PRODUCT TYPE
Flooring
WIDTH
7"
LENGTH
2′ – 10′ Random
INSTALLATION
- Plywood
- Waterfront
- Residential
- Commercial
- Radiant Heat & Concrete Slab
ENGINEERED WOOD FLOORING
-9-11 Layers -Plywood substrate -Hardwood wear layer dry sawn veneer -California Air Resource Board (CARB2) compliant -Moisture content of wear layer at time of manufacture may be from 6-9% -Wear layer thickness of 4mm nominal (specified textures and finishing process may slightly alter finished thickness)
FINISH
Prefinished
EDGE
Softened
GRADE
- Heirloom
- Signature
USE
Indoor
PROFILE
Tongue & Groove
STRUCTURE
Engineered
SPECIES
White Oak
SHEEN
Super Matte
WOOD
-Wood subfloors that allow for nailing (at industry prescribed schedule) require at minimum; the use of a caulking gun (such as Wakol MS 265) adhesive bead, applied across the full width of the planks at intervals of 8-12” in addition to mechanical fastening. Full-spread wood flooring adhesive applied by trowel to the substrate surface is recommended and will provide the most optimal method of glue-assist. -Flooring should be installed in the direction recommended by the Architect or Designer or parallel to the longest wall.
TEXTURE
Brushed
MINIMUM ORDER
400 SQ FT
MANUFACTURING PROCESS
- Product must be made in the USA
- Hot glue process for engineered structure
- Multi-point individual board press laminating process
SOLID WOOD FLOORING
- Moisture content should be in the 6-9% range.
- Milling tolerance must meet or exceed NWFA Standards.
- Relief grooves 3/8” deep, every ¾” across the bottom of the planks.
DETAIL
A barely-there finish is highlighted by specks of gray and white in the grainlines. Knotholes retain their natural color variations with their fill blending in as a rubbed gray. The result is a floor that is stunning in its naturalness.
INSTALLATION USING FULL-SPREAD GLUE REQUIRES
-Installation using full-spread glue requires the of use appropriate surface weight to properly set the individual board into the adhesive. Adhesive transfer of 95% or more to the bottom of the plank is required and must retain contact with the adhesive and substrate once dry and cured. 5 gallon buckets filled with sand or water are most commonly used for this purpose. Depending on adhesive requirement weights can typically be redistributed after 20 minutes. -Depending on subfloor conditions and nature of the adhe- sive the use of shims may be required to ensure flush edge and end joint configuration.
MATERIAL
- American White Oak.
- Super Matt Sheen 4-6o.
- 7 " wide planks, 2’-10' random lengths.
- T and G edge joints and end matched.
- NWFA/NOFMA Certified Manufacturer.
- 8” wide planks, 2’-12’ lengths with 6’-7’ average.
- Engineered or Solid Flooring is 3/4” total thickness.
-Softened edge on the 2 long sides of each plank of 1/32".
- Grade of material is a proprietary grade created by Carlisle. ژWood Filler is used in certain characterics within the plank face.
COLORS
COLORS
