Manuel Canovas L'envol Wallpaper
L'ENVOL WALLPAPER
L'ENVOL WALLPAPER
Into the sky, flying in the air, these delicately detailed balloons are hand painted in a very refined palette creating sophisticated colourways.
Be assured of being transported to new horizons with this glorious design.
INFORMATION
PRODUCT TYPE
Wallpaper
BRAND
Manuel Canovas
ENVIRONMENT
Indoor
DESIGN
Glorious Design
CODE
03079/01
COLLECTION
L'envol
COMPOSITION
100% Non Woven
PRODUCTION
Made in United Kingdom
USE
Use in many different rooms
PATTERN BOOK
Papierspeints Vol 8
AVAILABLE COLORS
5
DOWNLOADS
↓ Care
↓ Datasheet
colors
HANGING INSTRUCTIONS
INSPECT THE ROLL
Before cutting and hanging the wallcovering, ensure that all rolls have the same batch reference, are in good condition, with no variation in shade, and that no other faults are present. Please ensure that there are enough rolls to complete the job. Do not assume that the wallcovering will come off the roll the correct way up. Always refer to the pattern book or check with your retailer. Examination before hanging is the buyer's responsibility. No claim can be accepted after wallcoverings have been cut and hung, for defects which are apparent at the time of hanging. In the event of any complaint, please quote the reference and batch number on this label.
PREPARATION
-Walls should be clean, dry and even. -Roughen painted surfaces withsandpaper -Remove any old wallpaper and loose paint. -New plaster should be allowed to dry out completely -Scrape powdery, flaky surfaces. Absorbent surfaces should be prepared with an oil based primer ensuring it dries completely. -Dark coloured wallcoverings may need their edges coloured with a crayon of a similar tone to avoid white edges showing.
-Metallic effects can be damaged if high levels of alkaline are already present in the walls. Preparing the walls with an alkaline resistant primer should prevent any damage of this type. -For best results, we recommend that the walls are cross lined using a good quality lining paper. Sizing the lining paper will aid adhesion. Lining should be allowed to dry completely before hanging the wallcovering.
PASTE AND HANGING
-This is a 'paste the wall’ product. The decorator should paste the wall and not the back of the wallcovering. -A good quality, solvent-free, fungicide protected, heavy grade adhesive should be used. Do not use self-mix adhesives. All purpose pastes are not suitable. -Paste should be evenly applied to the wall tohang 1length at a time, to an area slightly wider than the width of the roll. -Buttjoinsanduseadecorator's brushtosmooth down thewall covering, working from the centre to the edges to express air bubbles.
-Avoid squeezing paste outofjoins andensure paste does not getonto the brush or roller. -No paste should beallowed to come into contact with the surface and hands should be kept clean and dry whilst handling the wallcovering. -Paste will damage the surface. The company cannot accept responsibility for marks or damage caused by paste. -Should any paste have been allowed tocome into contact with thesurface, itshould be lightly sponged whilst still moist, using a clean damp sponge.
-Trim top and bottom with a sharp knife or scissors. -Ensure wallcovering is firmly adhered as, in the event of fire, loose wallcoverings can contribute to the hazard. -After hanging 2or3lengths, inspect theresult toensure thatnoshading orother faults are present.