Carlisle Regur Flooring
REGUR FLOORING
REGUR FLOORING
Earthen Collection
Typically found in the lava covered valleys surrounding a volcano, Regur is partly born of fire. Gray is typically considered a cooler color but with the brown tones of the Hickory heartwood pushing to the surface Regur creates the warmth imagined in slowly flowing lava. With hints of black in the more open grain, creating a touch of the dramatic, this floor will be a supportive statement piece to all the architectural elements in your home.
INFORMATION
BRAND
Carlisle
PRODUCT TYPE
Flooring
LENGTH
2' - 12' Random
WIDTH
4" - 10"
THICKNESS
Engineered or Solid Flooring is 3/4” total thickness
ENGINEERED WOOD FLOORING
-9-11 Layers-Plywood substrate -Hardwood wear layer dry sawn veneer -California Air Resource Board (CARB2) compliant -Moisture content of wear layer at time of manufacture may be from 6-9% -Wear layer thickness of 4mm nominal (specified textures and finishing process may slightly alter finished thickness)
FINISH
Matte
USE
Indoor
TEXTURE
- Smooth
- Timeworn
- Brushed
- Footworn
- Hand Scraped Edge
EDGE
Tongue & Groove Softened Edge
PROFILE
3/4", tongue and groove edge
SHEEN
Extra Matte
STRUCTURE
Solid or Engineered
GRADE
- Original
- Heirloom
- Signature
SPECIES
Hickory
MINIMUM ORDER
800 SQ FT
MANUFACTURING PROCESS
- Product must be made in the USA
- Hot glue process for engineered structure
- Multi-point individual board press laminating process
SOLID WOOD FLOORING
- Moisture content should be in the 6-9% range
- Milling tolerance must meet or exceed NWFA Standards
- Relief grooves 3/8” deep, every ¾” across the bottom of the planks
INSTALLATION
Immediately following installation of the flooring materials, the woods surface should be thoroughly cleaned and appropriately protected to avoid damage to the flooring as other construction trades complete their responsibilities.
SURFACE
Wood subfloors that allow for nailing (at industry prescribed schedule) require at minimum; the use of a caulking gun (such as Wakol MS 265) adhesive bead, applied across the full width of the planks at intervals of 8-12” in addition to mechanical fastening. Full-spread wood flooring adhesive applied by trowel to the substrate surface is recommended and will provide the most optimal method of glue-assist.
DETAIL
-Flooring should be installed in the direction recommended by the Architect or Designer or parallel to the longest wall. -Expansion space of at least ½” is required around the perimeter of the installation in each room. -Installation using full-spread glue requires the of use appropriate surface weight to properly set the individual board into the adhesive. Adhesive transfer of 95% or more to the bottom of the plank is required and must retain contact with the adhesive and substrate once dry and cured. 5 gallon buckets filled with sand or water are most commonly used for this purpose. Depending on adhesive requirement weights can typically be redistributed after 20 minutes.
MATERIAL
- Brushed White Oak
- Naturals / Super Matte sheen 2-4°
- T and G edge joints and end matched
- NWFA/NOFMA Certified Manufacturer
- 8” wide planks, 2’-12’ lengths with 6’-7’ average
- Softened edge on the 2 long sides of each plank of 1/32” - ends are not ease
- Grade of material is a proprietary grade created by Carlisle. Wood Filler not allowed on the surface of the planks.
COLORS
ALL COLORS
