Watco Concrex Epoxy Repair Mortar Deep Fill
Concrex Epoxy Repair Mortar Deep Fill
CONCREX EPOXY REPAIR MORTAR DEEP FILL
Concrex® Deep Fill is designed to fill deep hole repairs to within 1/4in of the finished floor level before topping off with Standard Concrex Epoxy Repair Mortar. Concrex®
Deep Fill is specially formulated to allow quick and easy application of thicker layers.Deep Fill produces a coarse finish that can be over coated with Concrex Epoxy Repair Mortar Standard, Sub Zero or Rapid to produce a finer grade surface.
INFORMATION
FEATURES
- Navy Gray color
- Ready for traffic in 5 to 6 hours
- Excellent compressive strength
- Suitable for Concrete and Metal
- For interior and exterior applications
- Covers approximately 5 sq. ft. per 50 lb. kit at 1" thick
BRAND
Watco
PRODUCT TYPE
Mortar Repair
SUITABLE FOR
Sand & cement, concrete and metal
SKU
A080013
UPC
020066492441
COLLECTION
Concrex Epoxy
PRODUCTION
Made in United States
COVERAGE
5 sq. ft. per 50 lb. kit at 1" thick depth: apply from 1/2 to 4" per layer
PRIMER REQUIRED
A primer is not usually required if patch or crack repairing. Watco Tack Coat adhesive primer is recommended when applying Watco Concrex® Flex as a thin section screed or when applying to smooth, non-porous or metal surfaces. Wat
QUANTITY
1
USAGE INTERIOR/EXTERIOR
Interior or Exterior
COVERAGE
5 sq. ft. per 50 lb. kit at 1" thick depth: apply from 1/2 to 4" per layer
SUITABLE FOR
Deep holes in concrete, sand, cement and metal surfaces with heavy traffic
CURING TIME (HOURS)
5 to 6 hours in 60-70°F
POT LIFE
30 Minutes - 1 Hour
PROPERTIES
Provides excellent chemical resistance and anti slip properties
LIMITATIONS
Do not apply to wet surfaces. Do not apply thicker than 4in in one layer.
HOW TO APPLY
SURFACE PREPARATION
Surfaces should be clean, dry and free of all loose material. Wire brushing or sweeping is generally sufficient. If needed, wash with Bio-D or suitable degreaser or detergent solution, to remove grease and oil, rinse and allow to dry. If time constraints dont allow full drying, then use Tack Coat to prime damp areas
APPLICATION
Place the mixed material into the area to be repaired and spread out and finish with a steel trowel. To reduce drag on the trowel, wet the blade with mineral spirits. This will aid getting a smooth finish to the Concrex Deep Fill. Concrex Deep Fill is normally applied in thicknesses of 1/2-4 inches.
MIXING
Concrex Deep Fill should be stored at an ambient temperature above 50°F for approximately 8 hours prior to use. Do not use material if air and surface temperatures are below 50°F. Each pack of Concrex Deep Fill contains aggregate pre-blended with resin and the curing agent. Do not mix inside the plastic bucket. Wearing protective gloves, tip the aggregate on to a mixing tray or board. Shake the containers of curing agent thoroughly until the liquid is a uniform color. Form the aggregate into a mound and leave a small hole in the middle.
Empty the curing agent into the hole, ensuring the container is completely drained. Carefully mix the aggregate with the curing agent using a trowel until a smooth mortar is obtained, this will take several minutes. The more thorough the mixing, the wetter, smoother and more manageable the mix becomes. Alternatively, you can knead the mixture by hand, but you must wear suitable gloves. It is important to mix thoroughly until you achieve a consistent color.
