Watco Concrex Epoxy Repair Mortar Deep Fill Rapid
CONCREX EPOXY REPAIR MORTAR DEEP FILL RAPID
CONCREX EPOXY REPAIR MORTAR DEEP FILL RAPID
Concrex® Deep Fill Rapid is designed to quickly fill deep hole repairs ¼" to 4" deep and minimize downtime. Concrex® Deep Fill Rapid let's your floors get back to work in less time. With only two components, this mortar repair is easy to mix and apply.
INFORMATION
FEATURES
- Excellent compressive strength
- Ready for light traffic in 3 hours
- Suitable for Concrete and Metal
- Ideal for filling deep holes quickly
- For interior and exterior applications
- Covers approximately 5 sq. ft. per 50 lb. kit at 1" thick
BRAND
Watco
PRODUCT TYPE
Paint
SUITABLE FOR
Deep holes in concrete, sand, cement and metal surfaces with heavy traffic
SKU
A080051
UPC
020066367015
COVERAGE
5 sq. ft. per 50 lb. kit at 1" thick depth: apply from 1/2 to 4" per layer
COLLECTION
Concrex Epoxy
PRODUCTION
Made in United States
SURFACE
Clean and Dry
CURING TIME (HOURS)
2 hours at 70°F
USES
Repairing
COLOR
Navy Color
PROPERTIES
Provides excellent chemical resistance and anti slip properties
POT LIFE
30 Minutes - 1 Hour
USAGE INTERIOR/EXTERIOR
Interior or Exterior
LIMITATIONS
Do not apply to wet surfaces. Do not apply thicker than 4in in one layer.
HOW TO APPLY
SURFACE PREPARATION
Surfaces should be clean, dry and free of all loose material. Wire brushing or sweeping is generally sufficient. If needed, wash with Bio-D or suitable degreaser or detergent solution, to remove grease and oil, rinse and allow to dry. If time constraints dont allow full drying, then use Tack Coat to prime damp areas.
APPLICATION
Place the mixed material into the area to be repaired and spread out and finish with a steel trowel. To reduce drag on the trowel, wet the blade with mineral spirits. This will aid getting a smooth finish to the Concrex Deep Fill. Concrex Deep Fill is normally applied in thicknesses of 1/2-4 inches.
MIXING
Concrex Deep Fill should be stored at an ambient temperature above 50°F for approximately 8 hours prior to use. Do not use material if air and surface temperatures are below 50°F. Each pack of Concrex Deep Fill contains aggregate pre-blended with resin and the curing agent. Do not mix inside the plastic bucket. Wearing protective gloves, tip the aggregate on to a mixing tray or board. Shake the containers of curing agent thoroughly until the liquid is a uniform color.
Form the aggregate into a mound and leave a small hole in the middle. Empty the curing agent into the hole, ensuring the container is completely drained. Carefully mix the aggregate with the curing agent using a trowel until a smooth mortar is obtained, this will take several minutes. The more thorough the mixing, the wetter, smoother and more manageable the mix becomes. Alternatively, you can knead the mixture by hand, but you must wear suitable gloves. It is important to mix thoroughly until you achieve a consistent color.
