Carlisle Native Waypoint Flooring
Native Waypoint Flooring
NATIVE WAYPOINT FLOORING
You must be strong to face into the wind and keep moving forward. In homage to this fortitude, Windward brings a feeling of solidness and tradition to your floor. A natural, warm brown hue highlighted by a hint of gray in the grain patterns projects a time-tested strength and familiarity underfoot.
INFORMATION
BRAND
Carlisle
PRODUCT TYPE
Flooring
LENGTH
2' - 12' Random
WIDTH
2' - 12' Random
INSTALLATION
- Plywood
- Residential
- Commercial
- Radiant Heat
- Concrete Slab
- Waterfront
ENGINEERED WOOD FLOORING
-9-11 Layers -Plywood substrate -Hardwood wear layer dry sawn veneer
-Moisture content of wear layer at time of manufacture may be from 6-9% -California Air Resource Board (CARB2) compliant -Wear layer thickness of 4mm nominal (specified textures and finishing pro- cess may slightly alter finished thick-ness)
FINISH
Prefinished
EDGE
Prefinished
USE
Indoor
PROFILE
Tongue & Groove
TEXTURE
Smooth
SHEEN
Super Matte
STRUCTURE
- Solid
- Engineered
GRADE
- Heirloom
- Signature
SPECIES
White Oak
MINIMUM ORDER
800 SQ FT
MANUFACTURING PROCESS
- Product must be made in the USA
- Hot glue process for engineered structure
- Multi-point individual board press laminating process
SOLID WOOD FLOORING
- Moisture content should be in the 6-9% range
- Milling tolerance must meet or exceed NWFA Standards
- Relief grooves 3/8” deep, every ¾” across the bottom of the planks
WOOD
Flecks of gray in the wood’s grainlines add visual interest without distracting from the floor’s simple serenity. The result is a floor that serves as a calming backdrop for daily life.
SURFACE
Wood subfloors that allow for nailing (at industry prescribed schedule) require at minimum; the use of a caulking gun (such as Wakol MS 265) adhesive bead, applied across the full width of the planks at intervals of 8-12” in addition to mechanical fastening. Full-spread wood flooring adhesive applied by trowel to the substrate surface is recommended and will provide the most optimal method of glue-assist.
DETAIL
-Flooring should be installed in the direction recommended by the Architect or Designer or parallel to the longest wall. -Expansion space of at least ½” is required around the perimeter of the installation in each room. -Installation using full-spread glue requires the of use appropriate surface weight to properly set the individual board into the adhesive. Adhesive transfer of 95% or more to the bottom of the plank is required and must retain contact with the adhesive and substrate once dry and cured. 5 gallon buckets filled with sand or water are most commonly used for this purpose. Depending on adhesive requirement weights can typically be redistributed after 20 minutes.
MATERIAL
- White Oak
- T and G edge joints and end matched
- 8” wide planks, 2’-12’ lengths with 6’-7’ average
- Engineered or Solid Flooring is 3/4” total thickness
- Softened edge on the 2 long sides of each plank of 1/32”
- Grade of material is a proprietary grade created by Carlisle.
- Softened edge on the 2 long sides of each plank of 1/32” - ends are not ease
- Grade of material is a proprietary grade created by Carlisle. Wood Filler not allowed on the surface of the planks. Wood Filler not allowed on the surface of the planks.
COLORS
ALL COLORS
