Eco Surfaces E-TAK 99 Flooring
E-TAK 99 Flooring
E-TAK 99 FLOORING
E-TAK 99 is a premium, pressure sensitive, multi-flooring adhesive and plasticizer migration blocker. E-TAK 99 can be used with LVT, 2mm Sheet Vinyl, and VCR Sound Control Underlayments (ECOsilence).
INFORMATION
COLLECTION
E-TAK
BRAND
Eco Surfaces
PRODUCT TYPE
Flooring
TYPE
- LVT 2mm Sheet Vinyl
- One-Part Acrylic Works with
- VCR Sound Control Underlayments
LVT ONLY
Tacky/Pressure Sensitive Installations (see product sales sheet for details)
- Maximum RH: 99%
- Substrate pH: ≤12
- Working Time: Up to 4 hours
- Flash Time: As Required to Reach Full Flash
NON-POROUS/SMOOTH SUBSTRATE
1/16” x 1/32” x 1/32” U-notch; 210 SF/gal
FREEZE/THAW STABILITY
Protect from freezing
POROUS/ROUGH SUBSTRATE
1/16” sq. notch; 150 SF/gal
SHELF LIFE
1 year when store in original unopened packaging at 73°F (23°C)
DETAILS
Wet/Semi-Wet Adhesive Installations (see product sales sheet for details)
- Maximum RH: 95%
- Substrate pH: ≤11
FEATURES AND BENEFITS
- High moisture resistant
- Up to 2 hours of working time
- Low odor and VOC content
- Aggressive tack properties
ANTIMICROBIAL
Yes
PRODUCTION
Made in Italy
SURFACE PREPARATION
-All substrates must be structurally sound, dry, solid, and stable -Substrate should be clean and free of dust, dirt, oil, grease, paint, curing agents, concrete sealers, loosely bonded toppings, loose particles, old adhesive residues, and any other substance or condition that may affect the overall performance of the product.
SUITABLE SUBSTRATES
-Fully cured concrete at least 28 days old and installed according to ASTM F710 (see“Disclaimers” section) -Exterior-grade plywood, Group 1, CC type and other approved wood substrates (per the flooring manufacturer’s recommendations) -Exterior rated Portland-based self-leveling underlayments and patching compounds -Properly prepared, primed gypsum underlayments that meet the requirements for compressive strength according to ASTM F2419 -Radiant-heat systems that have been properly installed that are maintained at a maximum of 85°F (29.4°C) surface temperature.
LIMITATIONS
- For interior installations only
- Do not install over substrates containing asbestos.
- Do not install into wet adhesive over non-porous substrates.
- Do not apply directly over any adhesive residues, including cutback adhesive.
- Install flooring only in areas that are recommended by the flooring manufacturer.
- Use only when the substrate temperature is between 65°F and 90°F (18°C and 32°C).
- Do not install in areas with hydrostatic moisture, osmotic blistering, or alkali silica reaction conditions.
- Do not install unless the surface temperature of the substrate is 10°F (5°C) above the dew point.
- Do not install when the relative humidity (RH) of the concrete slab (ASTM F2170), or the pH, exceeds the limits listed in the table below.
