Kilz Kilz® Performance Caulk No. Pc10 Sealant
KILZ® PERFORMANCE CAULK NO. PC10 SEALANT
KILZ® PERFORMANCE CAULK NO. PC10 SEALANT
Kilz® performance caulk is a high-quality interior and exterior acrylic caulk that prevents craze cracking, shiners (gloss change/discoloration of paint film), and is easily applied with consistent flow/no air-pops.
This product is brush/roll paintable in 30 minutes, compatible with all oil and water-based paints, and can be spray painted immediately.
INFORMATION
BRAND
Kilz
PRODUCT TYPE
Sealant
PRODUCTION
Made in USA
PRODUCT NUMBER
PC10
SURFACE
Apply when sealant, surface, and air temperatures are above 40°F. For outdoor application caulked area should be painted over.
DRY TIME AT 77°F, 50% RH
Longer dry time required in cooler temperatures and in higher humidity.
- Full Cure : 2 weeks
- To Paint with Sprayer : Immediately
- To Paint with Brush/Roller : 30 minutes
-Shelf Life : 12 months, unopened and stored in a dry place between 40°F and 90°F
BASE POLYMER
Siliconized Acrylic
FLASH POINT
199.9°F Closed Cup
PACKAGING
10.1 oz.
VOC
<5 g/l
COLOR
White
DENSITY
12 lb/gal
CLEAN UP
Clean all tools and equipment with warm soapy water and rinse with warm clean water.
USE
Use for filling cracks or screw/nail holes in walls and ceilings of :
- Wood
- Plaster
- Gypsum
- Brickwork
- Concrete
- Other gaps and cracks prior to painting
COVERAGE
55 linear ft. at a 3/16" bead size
APPLICATION TEMPERATURE
40°F – 90°F
APPLICATION
Using proper safety precautions, cut the spout or tip of the cartridge at a 45° angle to the desired bead size. Load the cartridge into a caulk gun and squeeze the bead of caulk into the desired location. If the crack depth exceeds 1/2", use a backer rod material. Smooth the bead with a caulking tool or water and allow 30 minutes for caulk skin to form before painting with a brush/roller, or use a paint sprayer immediately. When finished be sure to remove and clean up all excess caulking material, and reseal cartridge for storage and reuse.
SURFACE PREPARATION & RECOMMENDED USES
The surface must be clean, dry, free of dust, chalk, oil, grease and all other loose materials. Use on properly prepared interior or exterior surfaces to seal connection joints such as :
- Molding
- Siding
- Stairs
- Baseboards
- Trim & Pipes
- Window Frames (Wood and Metal)
- Vents
- Skirtings
- Windowsills
- Corner joints
- Door Frames
- Concrete/Brickwork
