Watco V2100 System Enamel Spray Paint by Rust Oleum
V2100 SYSTEM ENAMEL SPRAY PAINT BY RUST Oleum
V2100 SYSTEM ENAMEL SPRAY PAINT BY RUST OLEUM
Rust-Oleum High Performance V2100 System Rust Preventive Enamel Spray Paint is ideal for industrial spray painting projects.
This tough spray paint provides a professional finish that resists chipping, cracking and peeling.
The advanced formula in this aerosol provides the best-possible corrosion protection with easy, one-coat coverage and long-lasting color, gloss and durability.
information
PRODUCT TYPE
Paint Spray
BRAND
Watco
SKU
V2171838
CURE TIME
Tack free in 20mins
SUITABLE FOR
- Metal
- Steel
- Masonry
- Wood
COLLECTION
Rust Oleum
COVERAGE
12-20 sq ft
AVAILABLE COLORS
Nine
USAGE INTERIOR/EXTERIOR
Interior or Exterior
FEATURES AND BENEFITS OF V2100 GALVANIZING SYSTEM SPRAY PAINT
- Withstands heat up to 200°F
- Dries to a touch in 20 minutes
- High-output tip covers 50% faster
- Can also be used as a touch-up paint
- Ideal for metal, steel, masonry and wood surfaces
- Meets USDA requirements for incidental food contact; accepted for use in federally registered Canadian food facilities; VOC-compliant nationwide
RECOAT TIME
Within 1 hour or after 24 hours depending on temperature
PRODUCTION
Made in United States
FINISH
Smooth & Glossy
PRIMER SUGGESTIONS
Not required, but for best performance, use with V2182838 Gray Primer.
DOWNLOADS
↓ V2100 Red
↓ V2100 Tan
↓ V2100 Blue
↓ V2100 White
↓ V2100 Black
↓ V2100 Yellow
↓ V2100 Orange
↓ V2100 Light Grey
↓ V2100 Dark Grey
↓ System Enamels
HOW TO APPLY
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
SURFACE PREPARATION - STEEL
Hand tool (SSPC-SP-2) or power tool (SSPC-SP-3) clean to remove loose rust, mill scale, and deteriorated previous coatings.
APPLICATION
Use when temperature is above 50°F (10°C) and humidity is below 85% to ensure proper drying. Surface temperature must be between 50-100°F (10-38°C). Use a primer on bare or rusted surfaces.Protect surrounding surfaces from overspray. Overspray can carry a significant distance. Shake can for one minute after mixing ball is heard. Hold can 10-14 inches from surface. Apply several light coats a few minutes apart to avoid drips and runs.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in trash compactor. Empty container can be recycled.
DRY & RECOAT TIMES
Recoat within 1 hour or after 24 hours. Allow more time in cooler temperatures.
SURFACE PREPARATION - PREVIOUSLY COATED
Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
COLORS
COLORS
