Osmo Wood Reviver Power Gel Varnishes
Wood Reviver Power Gel Varnishes
WOOD REVIVER POWER GEL VARNISHES
Gelatinous cleaner for refreshing and cleaning greyed wood in outdoor areas. Wood Reviver Power-Gel is a non-drip product, and so it is easy to apply –especially on vertical surfaces.
The gel penetrates the wood deeply and removes grey patina. Through subsequent re-oiling, the fresh warm wood colour is restored.
INFORMATION
BRAND
Osmo
PRODUCT TYPE
Varnishes
RECOMMENDED USE
Osmo Wood Reviver Power-Gel is highly recommended for timber decking, cladding, garden furniture and similar surfaces.
VISIBLE ONCE AGAIN
Revive the fresh, warm colour tones of wood – make them visible once again
APPLICATION TOOLS
Osmo Decking Cleaning Brush
COATS
1 coat, repeat if necessary
UNWEATHERED WOOD
Restores the natural characteristic of unweathered wood
EASY USE
Quick and easy to use
RECOMMENDED USE
Exterior wood surfaces
COVERAGE
10m²/L with one application, depends on condition of the wood
ENVIRONMENT
Outdoor
CODE
6609
RECOMMENDED USE
Exterior wood surfaces
PRODUCTION
Made in United Kingdom
DRY TIME
24-48 hours
COLOUR RANGE
Plus RAL, NCS and BS colour ranges
CLEAN UP
Immediately after use, with soap and water
STORAGE
Up to 2 years and longer if container is kept dry, closed tightly and stored at temperatures between 5 and 35°C. Do not expose to frost during transport
SIZES
500ml, 2.5L, 5L
BIODEGRADABLE
Odourless and biodegradable
INGREDIENTS
Osmo Wood Reviver Power-Gel contains biodegrada-ble oxalic acid (< 5 %). This product is free of solvents, formaldehyde, chlorine compounds and amines. Detailed declaration of ingredients available upon request.
CLEANING OF TOOLS
Immediately after use, with soap and water.
SPECIFIC GRAVITY
0.99-1.05 g/cm³
VISCOSITY
>70s DIN EN ISO 2431/3 mm, thixotropic
DOWNLOADS
↓ Safety Data
↓ Product Information
FLASH POINT
Not applicable
ODOUR
Faint/mild, after drying odourless
NOTE
Protect metal (e.g. hinges) and plants against direct contact (e.g. cover ornamental and farm plants with a tarpaulin.)
INSTRUCTIONS
SURFACE PREPARATION
-Remove debris from greyed wood with a stiff brush or broom; afterwards dampen with water. -Wood Reviver Power-Gel is ready to use. Do not thin. -Perform a trial application before treating wood with Wood Reviver Power-Gel.
NOTE
Osmo Wood Reviver Gel is most effective when applied onto bare, untreated timber. Existing treatments may block the revival process – always trial apply first. Protect/cover sensitive surfaces such as: plants, metallic components ( eg aluminium), sensitive stones and renders. After treatment the dried wood may appear quite light in colour. The fully refreshed colour of the wood should be revealed following the application of an Osmo finishing oil
METHOD OF APPLICATION
Generously apply the gel along the wood grain. After approx. 20 minutes reaction time, clean surface with Osmo Decking Cleaning Brush and rinse with plenty of water. Avoid pressure / jest washers for cleaning as they can significantly increase absorbency of some timbers ( eg soft timbers) .
After drying for approx 2-3 days in clement weather conditions, protect the newly refreshed wood with a wood finish (e.g. for decks – Osmo Natural Oil Woodstain or Osmo Decking-Oils). Check the moisture content of the wood is less than 20% RM prior to applying an Osmo wood finish. For machine processing on decking, we recommend using the Osmo Wood Orbiter.
