Kilz Kilz® Original Aerosol Interior Primer
KILZ® ORIGINAL AEROSOL INTERIOR PRIMER
KILZ® ORIGINAL AEROSOL INTERIOR PRIMER
KILZ® ORIGINAL Oil-Based Primer is a powerful stainblocking formula that blocks most heavy interior stains including water, smoke, tannin, ink, pencil, felt marker, grease, and also seals pet, food and smoke odors.
This convenient aerosol is ideal for small paint projects and spot priming interior surfaces including wood, drywall, plaster, paneling, wallpaper, masonry, brick, painted metal and properly prepared glossy surfaces†. Not recommended for mold or mildew-prone surfaces or flooring.
INFORMATION
APPLICATION TEMPERATURE
- Minimum : 50°F (10°C)
- Maximum : 90°F (32°C)
BRAND
Kilz
PRODUCT TYPE
Paint
INT/EXT
Int
BASE
Oil
DRY TO TOUCH
15 - 30 min
DOWNLOAD
↓ Data Sheet
SURFACE PREPARATION
-The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew, and/or wallpaper paste. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry. -Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.* -Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.*
COLOR
White
FINISH @ 85°
< 10
DRY TIME @ 77°F (25°C), 50% RH
-To Recoat / Topcoat: 1 Hour
-Longer dry time may be required in cooler temperatures and in higher humidity.
WEIGHT SOLIDS
40.0% (+/-) 2%
VOLUME SOLIDS
18.0% (+/-) 2%
APPLICATION
-Eye protection is recommended. -For best results, use at room temperature. Cover adjacent areas to protect from overspray. -Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 12" from area being painted. 2-3 thin coats produce best results. -Topcoat with latex or oil-based paint after 60 minutes. NOTE: On some surfaces, spot priming may cause a non-uniform appearance in the final coat. To avoid this, prime the entire surface.
DRY TO RECOAT
1 hour
MAX VOC (BY WEIGHT)
60%
MAX PRODUCT WEIGHTED MIR
1.2
COVERAGE
20 - 25 sq. ft.
FLASHPOINT
-156°F (-104°C)
CLEAN-UP & DISPOSAL
-Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. If spray nozzle becomes clogged, remove and clean. -Do not stick pins or wire into can opening. -Clean fresh overspray with mineral spirits or paint thinner. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate.. -Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.
