Kilz® Original Low Odor Interior Aerosol Primer
KILZ® ORIGINAL LOW ODOR INTERIOR AEROSOL PRIMER
KILZ® ORIGINAL LOW ODOR INTERIOR AEROSOL PRIMER
Kilz® original low odor is an oil-based sealer, adhesion promoter and stain blocker with less odor than typical oil based primers.
It also features fast odor dissipation technology which means no lingering odor†.
Ideal for use in offices, schools, dining areas, apartments and other areas which are sensitive to solvent odors or high odor levels. Use KILZ ORIGINAL LOW ODOR to block stains including water, tannin and smoke from tobacco and fire. Not recommended for floors.
INFORMATION
APPLICATION TEMPERATURE
- Minimum : 50°F (10°C)
- Maximum : 90°F (32°C)
BRAND
Kilz
PRODUCT TYPE
Paint
INT/EXT
Int
BASE
Oil
DRY TO TOUCH
15 - 30 min
DOWNLOAD
↓ Data Sheet
SURFACE PREPARATION
-The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew, wallpaper paste. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.
-Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.*
-Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.*
CLEAN-UP & DISPOSAL
-Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. If spray nozzle becomes clogged, remove and clean. -Do not stick pins or wire into can opening. -Replace nozzle with valve opening pointed away from you. Clean fresh overspray with mineral spirits or acetone. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate. -Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.
COVERAGE
20 - 25 sq. ft.
DRY TO RECOAT
1 hour
MAX VOC (BY WEIGHT)
60%
MAX PRODUCT WEIGHTED MIR
0.7
DRY TIME @ 77°F (25°C), 50% RH
-Topcoat with latex or oil-based paint after 60 minutes. -Longer dry time may be required in cooler temperatures and in higher humidity.
COLOR
White
FINISH @ 85°
< 10
WEIGHT SOLIDS
42.2% (+/-) 2%
VOLUME SOLIDS
16.5% (+/-) 2%
APPLICATIONS
-Eye protection is recommended. -For best results, use at room temperature. Cover adjacent areas to protect from overspray. -Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 12" from area being painted. 2-3 thin coats produce best results. -Topcoat with latex or oil-based paint after 60 minutes. NOTE: On some surfaces, spot priming may cause a non-uniform appearance in the final coat. To avoid this, prime the entire surface.
