Kilz Kilz® Mold & Mildew Interior | Exterior Aerosol Primer
Kilz® Mold & Mildew Interior | Exterior Aerosol Primer
KILZ® MOLD & MILDEW INTERIOR | EXTERIOR AEROSOL PRIMER
KILZ® MOLD & MILDEW† Aerosol Primer is a water-based primer-sealer-stainblocker that is specially designed for residential surfaces in high humidity, moisture and temperature environments such as kitchens, bathrooms, powder rooms and laundry rooms.
This convenient aerosol is ideal for small paint projects, spot priming and touch-ups for these spaces. It offers excellent adhesion to both interior and exterior surfaces and provides a sound anchor for paints.
The EPA registered active ingredient creates a mold and mildew-resistant film that protects the primer film from mold and mildew growth.
INFORMATION
BRAND
Kilz
PRODUCT TYPE
Paint
CLEAN UP
For recycling or disposal information, contact your local household refuse collection service.
PRODUCTION
Made in USA
COLLECTION
Mold
CLEAN-UP & DISPOSAL
-Please consider donating any unused product. -Replace nozzle with valve opening pointed away from you. -If spray nozzle becomes clogged, remove and clean. Do not stick pins or wire into can opening. -Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. -Clean fresh overspray with mineral spirits or paint thinner. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate.
BASE
Oil-Based
COLOR
White
DRY TIME @ 77°F (25°C), 50% RHl
- To Recoat: 1 Hour
- To Touch: 15 – 30 minutes
FLASHPOINT
-156°F (-104°C)
FINISH @ 85°
< 10.0
APPLICATION
- Eye protection is recommended.
- For best results, use at room temperature.
- 2 - 3 thin coats produce best results.
- Cover adjacent areas to protect from overspray.
- Topcoat with water-based or oil-based paint after 60 minutes.
- Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use.
- Hold can upright, moving from side-to-side while spraying lightly and evenly about 12" from area being painted.
COVERAGE - LOW
20 sq. ft.
COVERAGE HIGH
25 sq. ft.
DRY TO TOUCH
15-30 min
DRY TIME @
77°F (25°C), 50% RH
VOLUME SOLIDS
16.4 ± 2%
WEIGHT SOLIDS
37.1 ± 2%
MAX VOC (BY WEIGHT)
60%
RESULTS
2 - 3 thin coats produce best results
CLEAN
The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew and wallpaper paste.
SUBSTITUTE
If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.
DRY TO TOUCH
15-30 min
DRY TO RECOAT
1 hour
SURFACE PREPARATION
-Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.* -†Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.* -Mold or Mildew Covered Surfaces: Any existing mold and/or mildew on the surface MUST be removed before priming or painting. Wash the area with a mildew remover, rinse with water and allow to dry before priming.
FEATURES
