Volteco Amphibia 3000 Grip Waterproofing Materials
AMPHIBIA 3000 GRIP WATERPROOFING MATERIAL
AMPHIBIA 3000 GRIP WATERPROOFING MATERIAL
Self-fastening, self-repairing and self-sealing hydro-reactive multilayer waterproof membrane for pre-applied installation.
information
AMPHIBIA PRESSURE LINE
Steel straight profile coated on one site with Amphibia 3000
- Length = 1.5 m (59.06 in)
- Height = 5 cm (1.97 in)
- Package = 10 pcs
BRAND
Volteco
PRODUCT TYPE
Waterproofing Materials
FIELDS OF APPLICATION
-In foundation beds with Amphibia application before concreting -To protect overlaps when used against gas ingress, in particular radon and methane gas
ADVANTAGE
- High resistance to hydraulic load
- High flexibility and capacity to bridge cracks
- Absolute impermeability with no side seepage of water
- Immediate mechanical protection, self-repairing also on accidental holes
DOWNLOADS
↓ Safety Data Sheet
↓ Technical Data Sheet
↓ Specifications Sheet
↓ DS_Construction joint with AMPHIBIA 3000 GRIP under the slab and PLASTIVO on the foundation walls_516_EN.pdf
VISIBLE DEFECTS
No visible defect
STRAIGHTNESS
70 mm
MASS PER UNIT AREA
1.6 ± 0.2 kg/m²
THICKNESS
1,6 ± 0,2 mm
BOND STRENGTH A 28 GG
> 1.5 N/mm² (UNI EN 1542)
SEALING OVERLAPPINGS
-To prevent the overlaps of sheets from opening during subsequent processes (e.g. in the case of pre- applied installations: reinforcement installation and concrete casting), they must be sealed with suitable protection. -Wait 1-2 hours after applying AMPHIBIA 3000 GRIP before proceeding with sealing. See options in the following layout.
WATER TIGHTNESS
No passage
RESISTANCE TO STATIC LOAD
20 kg
PRE-APPLIED APPLICATION
The formwork spacer holes need to be sealed with the relative plastic AMPHIBIA STOPPER in different shape according to their diameter
-In case of tubes diam. 20-22 make an AKTI-VO 201 edge (see relevant technical data sheet) on the stopper fins near the dis - In case of tubes diam. 24 make two adjacent AKTI-VO 201 beads on the stopper fins near the disc -In case of tubes of different diameters or metal spacers on traditional wooden formworks, use AMPHIBIA 3000 STRIP fixed with BI MASTIC (see relevant technical data sheet)
PRE-APPLIED INSTALLATION
Even out the installation surface with lean concrete casting which must be sufficiently smooth and uniform.Apply AMPHIBIA 3000 GRIP with the non-textile surface facing upwards, with staggered joints and overlapping the edges by 5 cmBegin application by laying AMPHIBIA 3000 GRIP H.90 along the entire perimeter lengthwise on the formwork, securing it at the edge of the formwork by means of a stapler (staples with 6-7 mm long points) and overhanging it 5 cm beyond the level of the finished bed Seal vertical overlaps against formwork with BI MASTIC, if necessary supplementing the fixing with staples. Reinforce the corners with AKTI-VO 201 or BI MASTIC. Then complete applying AMPHIBIA 3000 GRIP, sealing all the overlaps between the sheets with AMPHIBIA SAFETY TAPE.Use BI MASTIC wherever a more tenacious adhesion of the overlaps is needed
