Volteco Spidy 15 Cement-based Mortar
SPIDY 15 CEMENT-BASED MORTAR
SPIDY 15 CEMENT-BASED MORTAR
Pre-mixed quick-setting cement-based mortar for quick repair jobs on reinforced cement and cement-based surfaces in general.
information
ADVANTAGE
- Good finish results
- High adhesion to concrete and reinforcement bars
- Excellent thixotropy that does not require the use of formwork
- Rapid-setting also on surfaces and in particularly damp environments
BRAND
Volteco
PRODUCT TYPE
Cement-based Mortar
COMPRESSIVE STRENGTH
- After 3 h : > 5 N/mm² (UNI EN 196)
- After 1 day : > 18 N/mm² (UNI EN 196)
- After 7 days : > 30 N/mm² (UNI EN 196)
- After 28 days : > 35 N/mm² (UNI EN 196)
FLEXURAL STRENGTH
- After 3 h : > 1 N/mm² (UNI EN 196)
- After 1 day : > 3 N/mm² (UNI EN 196)
- After 7 days : > 4 N/mm² (UNI EN 196)
- After 28 days : > 5.5 N/mm² (UNI EN 196)
DOWNLOADS
↓ Safety Data Sheet
↓ Technical Data Sheet
↓ Specifications Sheet
↓ DS_Construction joint with AMPHIBIA 3000 GRIP under the slab and PLASTIVO on the foundation walls_516_EN.pdf
PRODUCTION
Made in Italy
WORKABILITY TIME
At +20°C < 15'
APPEARANCE
Grey Powder
SHRINKAGE
Controlled
BOND STRENGTH A 28 GG
> 1.5 N/mm² (UNI EN 1542)
SAFTEY
- This is a non-toxic alkaline product.
- It is recommended to use a mask and gloves while working.
- Accidental contact with eyes, rinse thoroughly with water and seek medical advice.
MATERIAL
Cement
WEIGHT
< 2.2 kg/l
PRODUCT APPLICATION
-Quick preparation for waterproofing jobs (for example on reinforcing fillets, to plaster formwork spacers) -To rapidly repair deteriorated concrete structures (e.g. edges of beams, columns and balcony bands) -Fastening of railings and traps -To rapidly repair superficial concrete casting defects (such as gravel nests, protruding bars and chipped parts) -To rapidly position counter-frames, door and window frames and electrical systems
CONSUMPTION AND YIELD
- 19 kg/m² per centimetre of applied thickness.
- A bag of SPIDY 15 yields about 8 l of mortar.
PACKAGING AND STORAGE
- 15 kg bags.
- The products must be stored in a dry place protected from sun and humidity.
PREPARING THE MIXTURE
Spidy 15 is ready to use; pour the mixing water into a container (approx. 2.5 l per bag equivalent to 16% in weight) and slowly add the powder, mixing it with a drill-mixer for about 3 minutes, until a smooth mixture is obtained.
PREPARING THE SURFACES
Perfect adhesion of the product to the surface, which is absolutely necessary to ensure repair resistance, depends on the quality of the surface preparation on which the mortar is to be applied. Therefore, the following steps must be carried out in advance :
-Carefully remove all deteriorated parts by sand-blasting or bush-hammering -Roughen the surface, removing any film or cement slurry -Clean each exposed reinforcement bar from rust and apply protective sanofer by brush on the cleaned bars -Thoroughly soak the surfaces with water, keeping them damp from when the application process begins
