CTS FLOW Control Cement
FLOW CONTROL CEMENT
FLOW CONTROL CEMENT
Additive to Increase Strength and Fluidity
FLOW Control is an additive that increases the fluidity of Rapid Set cement products. FLOW Control can increase compressive strength of Rapid Set cement products by reducing mix water. Add up to 4 packets maximum per 50-lb to 70-lb bag of Rapid Set cement product.
INFORMATION
BRAND
CTS
PRODUCT TYPE
Cement
USES
Use FLOW CONTROL with Rapid Set cement products. Add 1 to 4 packets of FLOW CONTROL to increase fluidity, and/or increase strength to satisfy jobsite requirements. A trial batch is recommended to fine-tune the dosage. FLOW CONTROL may be used in combination with all other products of the Rapid Set® Concrete Pharmacy®.
DIRECTIONS
Place desired amount of potable water into mixing container. Add half cement product into mixing container and mix with mechanical drill/mixer. Continue mixing while adding FLOW CONTROL 2.1-oz (60-grams) powder to mixing container. Add remaining cement product into mixing container. Follow product mixing instructions and maximum water requirements described on the package of the cement product. Mix to a workable, lump-free consistency. Do NOT exceed 4 packets per 50-lb to 70-lb bag of Rapid Set branded cement product. Too much water in the mixture may cause aggregate segregation, which can reduce strengths.
DOWNLOAD
↓ Data Sheet
PRODUCTION
Made in United States
USER RESPONSIBILITY
Before using Rapid Set products, read current technical data sheets, bulletins, product label and safety data sheet at www.CTScement.com. It is the user’s responsibility to review instructions and warnings for any Rapid Set product in current technical data sheet, bulletins, product label and safety data sheet prior to use.
MANUFACTURER
CTS Cement Manufacturing Corp. 12442 Knott St. Garden Grove, CA 92841 Tel: 800-929-3030 | Fax: 714-379-8270 Web: www.CTScement.com E-mail: [email protected]
DETAIL
-Increases fluidity or reduces water. -Increases compressive strength. -Use only with Rapid Set® cement products.
SHELF LIFE
Flow control has a shelf life of 12 months when stored properly in a dry location, protected from moisture, out of direct sunlight, and in an undamaged package.
DESCRIPTION
Rapid Set® FLOW CONTROL is a flow enhancing additive that allows higher fluidity or lower water requirement. Reducing water content by adding FLOW CONTROL will increase the final strength and durability.
USE
For use with Rapid Set® cement products
FLOW CONTROL
Additive to Increase Strength and Fluidity
WARNING
Causes mild skin irritation. May be harmful in contact with skin. Causes serious eye irritation. Protect eyes with goggles or safety glasses with side shields. Cover skin with protective clothing. Use chemical resistant gloves and waterproof boots. In case of skin contact, immediately wash with soap and water. In case of eye contact, flush immediately and repeatedly with clean water, and consult a physician. Use a NIOSH/MSHA approved respirator if there is a risk of exposure to dust/fume at levels exceeding the exposure limits.