Winkler One Flooring Cement
ONE FLOORING CEMENT
ONE FLOORING CEMENT
One Flooring is a single-component coloured liquid waterproofing membrane with high UV-resistant protection specifically formulated to ensure long-lasting waterproofing, and durable ‘drive-over’ protection to treated substrates.
Applicable both indoors and outdoors in extreme conditions: low and high temperatures (from 0°C to +45°C), on damp, very humid or wet substrates. The product remains stable to thermal shocks.
Specific for waterproofing and protecting floors also subject to strong stresses, such as: garages, parking lots in general, industrial floors, cement screeds that are not completely cured (e.g., 7 days at 15°C), substrates in: concrete, tiled and with permanent problems of excess moisture.
The product, when fully cured, is resistant to wear from the passage of rubberized vehicles, even intense and hard tyres. Its particular formulation allows optimal adhesion, even on asphalt substrates, as long as it is compact and with good mechanical strength (≥ 0.5N/mm²). Once applied, after a few hours it is completely out of the rain (refer to the table on the technical data sheet).
information
PRODUCTION
Made in Italy
PRODUCT TYPE
Cement
FIRE REACTION
Cfl - s1
MECHANICAL STRENGTH
≥ 0.5N/mm²
CONSUMPTION
-1.7 - 1.9 kg/m² without reinforcement. -1.8 - 1.9 kg/m² with the interposition of one mat.
COLOR
- Light Grey
- Grey
- Red
- Green (White And Yellow For Signs).
LOW & HIGH TEMPERATURES
From 0°C to +45°C
ROLLER OR METAL TROWEL
1.1-1.2 kg/m²
WEAR RESISTANCE TO ROTATING LOADS
≤ RWA10 (≤ 10cm3)
PACKAGING WEIGHT
10 - 20 kg buckets.
CERTIFICATION
UNI EN 13813 : Synthetic resin (RWA10-IR4-B2,0-Ffl)
STORAGE
The product, in its undamaged packaging and stored in a dry and protected place, has a shelf-life of 12 months. Store at temperatures between +5°C and +35°C. Accessories: BC Seal Band, BC Seal Pad, Winjoint Foam, Winjoint Seal, One Mat.
ADHESION STRENGTH
B2.0 (≥ 2.0 N/mm2)
PROTECTION
High UV-resistant Protection
PROTECTION
High UV-resistant Protection
DOWNLOAD
↓ Data Sheet
CATEGORY
Liquid, paste and cement-base waterproofing products innovations
USEFUL ADVICES
Make sure that the supports are clean and free from crumbly, detached parts, foreign or non-sticking substances. Apply in two coats. To obtain an optimal finish, apply the second coat of the product with a short-haired roller both longitudinally and transversely. SURFACES WITH JOINTS: The joints must always be respected and waterproofed with a suitable polyurethane sealant.
USE
- Indoor
- Outdoor
MATERIAL
- Cement
- Concrete
APPLICATION
It can be applied with a spatula or short-haired roller. Apply the first coat by short-haired roller for a consumption of 350-400g/m². Wait for the time indicated on the temperature table, then apply the second coat, always with roller or metal trowel, for a rate of 1.1-1.2 kg/m². The use of a spiked roller after the second coat, before it cures, is always recommended. For any repairs to the surface, pre-one mortar or unibar formula and unibar malta can be used. In case of an oil-polluted substrate, provide for the use of one primer or technoasfalt where applied on asphalt (see technical data sheet). In case of application on substrates subject to movements, it will be necessary to interpose one mat in between.