Hollaender Vision™ Al Railing
VISION™ AL Railing
VISION™ AL RAILING
VISION™ aluminum railing is a system designed with “in-line” panel clips that support the infill panel. Although the standard infill is glass, metal infills in stainless steel are available in wire mesh and perforated designs, with 304 SS as standard or 316 as an option.
Acrylic and other custom infill materials are also available. Glass or other infill panels are retained by 4 rounded panel clips. Glass panels will have holes for the bottom 2 clips. Glass infill is available in 3/8” monolithic or 7/16” laminated glass. Assist rails in aluminum are available for stairs or for level railing as on option
INFORMATION
BRAND
Hollaender
PRODUCT TYPE
Railing
FITTING
Aluminum 6063-T6 (clear anodized)
APPLICATIONS
-Exterior -Interior
USE
-Handrails -Guardrails -Balconies
RAILS
Aluminum 6063-T6, 1 ½” IPS (48.2 mm O.D.) Schedule 40 Wall (clear anodized)
POSTS
Aluminum 6005-T5, 1 ½” IPS (48.2 mm O.D.) Schedule 80 Wall (clear anodized)
FINISH
Clear anodized finish railing with 3/8" thick tempered glass and wire mesh steel infills
TECHNICAL DRAWING
CERTIFICATION
Meets IBC and ADA codes, U.S. International Building Code 2009/2012/2015/2018 standards specific to guardrails, handrails and infill panel materials including glass
OVERALL DIMENSIONS
-Height of top rail above walking surface : 42 in.
-Post spacing : Determined by site conditions.
-Mounting : Determined by site conditions.
BASE FLANGES
Cast aluminum
FASTENERS
Stainless steel 304 alloy
PROPERTIES
Security
INFILL
-Glass -Wire Mesh
CHARACTERISTICS
- Aluminum, in-line panel clips
- Choice of infill panels
PERFORMANCE REQUIREMENTS
All railings shall be supplied to conform to applicable sections of the following codes:
- ADAAG
- International Building Code
RAILING
-Interna-Rail®-Structural Glass Railing, VISION™ AL Railing
CODE COMPLIANCE
U.S. International Building Code 2009/2012/2015/2018 standards specific to guardrails, handrails and infill panel materials i
GENERAL
VISION™ aluminum railing is designed for glass, resin, or metal infill panels, and is used in all railing applica-tions that must comply with IBC codes for structural strength and dimensions. It is designed so that the glass or metal infill is “in line” with the center line of the posts. Both aluminum VUE™ and stainless steel VISION™ rail- ings are “offset” from the center line of the posts.