Saniflo Sanicubic 1 GR Macerating Lifting Station
SANICUBIC 1 GR LIFTING STATION
SANICUBIC 1 GR MACERATING LIFTING STATION
The Sanicubic 1 GR is ideal for sloping waterfront properties where a boathouse could be converted into additional accommodation, rural properties where main drainage is too far away
- Single phase
- Adjustable cutter assembly
- Up to 20m vertical lifting
It features a powerful 2200W motor, high flow rate performance, and an IP68 waterproof rating.
INFORMATION
PRODUCTION
Made in Australia
ELECTRICAL CLASS
I
IP RATING
IP68
USE
Macerating Lifting Station
RPM ( REVOLUTION PER MINUTE )
2800
POWER CABLE: TYPE, SECTION
H05 VV-F 3G
SECTION
1.5
VOLTAGE
230 V
MAXIMUM FLOW RATE
17 m³ / h
NUMBER OF ENTRIES
7
APPLICATION
Locations far from mains drainage
EXT. VENTILATION DIAMETER
75 mm
POWER CONSUMPTION P1
2200 W
FLOW RATE
17 mз /h
FREQUENCY
50-60 Hz
POWER OUTPUTP2
1700 W
ALARM LEVEL
180-290 mm
FLOW RATE PERFORMANCE CHART
VERTICAL/HORIZONTAL PERFORMANCE
Increase size of horzontal run by one pipe size after 5m. All horizontal pipework requires a minimum of 1:100 fall.
TOTAL VOLUME
55 L
ON/OFF LEVEL
140-250/30 mm
TECHNICAL CHARACTERISTICS
- Voltages : 220-240 V/50 Hz
- Working Waste Water Temp : 55°C Max (intermittent)
- Inlet Pipework : 50/100 mm
CHARACTERISTICS
- Powerful Motor
- High Flow Rate
- Waterproof
- Compact
- Tough
- Reliable
TYPE OF IMPELLER
Grinder
TYPE OF ACTIVATION
Pneumatic
MATERIAL
- Tank : PE LD
- Shaft : Stainless teel
- Pipework : Stainless steel
- Pump Housing : GG-20
- Motor Housing : GG-20
- Impeller : GG-20
DISCHARGE PIPEWORK
40 mm
MOTOR POWER
2200 Watts
DIMENSIONS
- Length : 570 mm
- Height : 439 mm
- Depth : 460 mm
LOGISTICS
- Gross weight : 64 kg
- Barcode : 3308815079110
- Factory code : CUBIC1GRSE71-1S
POWER CABLE: LENGTH
1.5 m
MAX. TEMPERATURE OF THE PUMPED LIQUID (5 MIN)
55°C
DISCHARGE DIAMETER DN
50
TYPE OF CONTROL BOX
ZPS 1 case
CONTROLLER CHARACTERISTICS
-Clear LCD display -Internal acoustic alarm -Programmable operation and fault signa -Maintenance interval counter -Recording of the fault protocol -Electronic monitoring of the motor current -Internal pressure sensor
