Novamix Protect 100 Surface Coating
PROTECT 100 SURFACE COATING
PROTECT 100 SURFACE COATING
Waterproofing protection for natural stones, mortars and concrete in internal and external areas
Silicone based water repelling agent for the waterproofing protection of natural stones, veneer bricks, renders, cement based joints between tiles and mineral surfaces.
It provides good waterproofing protection while in the same time it allows to the surface to ‘breathe’. It is suitable also for external areas.
INFORMATION
BRAND
Novamix
PRODUCT TYPE
Surface Coating
CHEMICAL SUBSTANCE
- Polysiloxane
- Siloxane water dispersion
PACKAGE
- Containers 1 L
- Containers 20 L
- Containers 5 L
PRODUCTION
Made in Greece
COLOR
White
FORM
Liquid
DENSITY
1.0 ± 0.1 kg/L
PACKAGING
Buckets of 1, 5 and 20 liters
CONSUMPTION
0.1-2 L/m²
RECOMMENDATIONS
-Apply only on structurally stable and well prepared substrates -Avoid direct exposure to sunlight and/or strong wind and rain -Do not add water or other liquids -Do not apply upon wet surfaces -In natural stones it is recommended to perform a trial test before -Do not apply when the substrate & ambient temperatures are lower than +5°C and higher than +35°C
STORAGE
PROTECT 100 remains stable for at least 12 months from the production date in the original sealed packaging stored in a dry place and temperature between +5°C and +35°C.
CERTIFICATIONS
CE marked with DoP C04069-CPR-2030942 by factory certification number 1128 of the factory production control. According to the current harmonized standard ELOT EN 1504-2 as a surface protection product Principle 2, Method 2.1 hydrophobic impregnation for the protection of concrete from moisture
PALLET
-450 L -480 L
APPLICATION TEMPERATURE
From +10°C up to +35°C
PROTECT 100 IS SUITABLE AS HYDROPHOBIC IMPREGNATION AND PROTECTION FROM OILY POLLUTANTS FOR:
- Concrete and cement mortars
- Renders and masonry plasters
- Natural stones, grouts, cotto tiles
- Microcement screeds of planocolor microcement system and novacem creative
FINAL PERFORMANCES ACCORDING TO ΕΝ 1504-2:2004
| APPLICATIONS | PERFORMANCE | REQUIREMENT | METHOD |
|---|---|---|---|
| Penetration depth | 8 mm | Class Ι, <10 mm | EN 14630 |
| Absorption ratio compared to untreated sample | 5,6% | < 7,5% | ΕΝ 13580 |
| Absorption ratio after immersion to alkaline solution | 6,4% | < 10% | ΕΝ 13580 |
| Drying rate for hydrophobic impregnation | 70% | Class Ι, >30% | ΕΝ 13579 |
APPLICATION PROCEDURE
ROLLER
It applied with light pressure until saturation. If required a second layer can be applied perpendicular to the first within 30 minutes.
BY IMMERSION
Immersion must be done inside clean containers. The immersion time is from 10 to 30 minutes depending on the absorbency of the waterproofing surface. Surfaces treated with PROTECT 100 must be protected for at least 5 hours from rain and high temperatures.
APPLICATIONS
PROTECT 100 is applied undiluted with roller, spray or by immersion. The application surface must be dry, clean, free of dust and in general materials which might compromise adhesion.
AIRLESS SPRAY
Spraying is done with suitable equipment from a distance of 25 - 30 cm from the surface, taking care the material to be absorbed until saturation. It is recommended that the application be done from top to bottom and when applied outdoors no strong winds must be present.