Saniflo Sanicubic 2 Pro Macerator Pump
SANICUBIC 2 PRO MACERATOR PUMP
SANICUBIC 2 PRO MACERATOR PUMP
The Sanicubic 2 Pro is a high performing macerator pump that enables the removal of grey and black water from any commercial premises from a distant basement. It contains two separate, load balanced pumps with high performance macerating systems and will operate alternatively.
In the event of inflow overload, both motors run at the same time or in the unlikely event that one motor fails, the other one will take over.
- Discreet installation
- Various configurations possible
- Certified watertightness
- Remote control as standard
INFORMATION
BRAND
Saniflo
USE
Macerator
VOLTAGE
230 V
MODE OF OPERATION
S3 30%
LOGISTICS
- Gross weight : 35 kg
- Barcode : 3308815074450
- Factory code : R4STDIP68NM
POWER
- Power output P2 : 1050 W
- Power consumption P1 : 1500 W
NUMBER OF ENTRIES
4
TYPE OF CONTROL BOX
Classic
MAX. HEAD (Q0)
13 m
IP RATING
IP68
FREQUENCY
50-60 Hz
DISCHARGE PIPEWORK
50 mm
APPLICATION
-Bathroom -Toilet -Basin -Shower -Bathtub
MATERIAL
- Tank : PP
- Pump housing : PA 12 GF
- Motor housing : PA 12 GF
DIMENSION
- Length : 597 mm
- Height : 495 mm
- Width : 517 mm
CABLE LENGTH
- For Control Panel : 4 m
- For Wired Alarm Panel : 5 m
CHARACTERISTICS
-Quiet Technology -Large Tank Capacity -Neat And Functional Design -Durable Motor
FLOW RATE PERFORMANCE CHART
VERTICAL/HORIZONTAL PERFORMANCE
Increase size of horizontal run by one pipe size after 5m. All horizontal pipework requires a minimum of 1:100 fall.
FEATURES
- Ideal for busy business environments and larger domestic situations
- Tough, reliable macerator pump
- New design with easily removable motor for servicing and maintenance
- Load balanced twin macerator pumps for a failsafe system
- Alternate activation ensures even wear of motors
- Two alarms for ultimate safety – hard-wired alarm plus remote wireless alarm
- Centre heights of inlets 140 mm
- Working temperature of 35°C. Will handle up to 70°C for short periods.
- IP68 rated
- Can be connected to a Building Management System
- Base of pump needs to be minimum 275 mm below lowest fixture
- Allow 200 mm clearance around pump for maintenance purposes
HYDRAULICS SPECIFICATION
| Parameters | Sanicubic 2 Pro |
|---|---|
| Max. head (Q0) | 13 m |
| Maximum flow rate | 40, 50, 100, 110 mm |
| External inlet diameter | 50 mm |
| Ext. ventilation diameter | 50 mm |
| Total volume | 45 L |
| Useable volume | 17.5 L |
| ON/OFF level | 140/70 mm |
| Alarm level | 210 mm |
| Max. incoming temperature | 70 °C (5 mins) |
| Type of impeller | Grinder |
| Type of activation | Pneumatic |